Guidelines For Using 1100 Series Lightweight Access Points; Using Dhcp Option 43 - Cisco AIR-AP1120B-A-K9 - Aironet 1100 Series Access Point Hardware Installation Manual

Guidelines for Using 1100 Series Lightweight Access Points

Guidelines for Using 1100 Series Lightweight Access Points
Keep these guidelines in mind when you use a 1100 series lightweight access point:
•
•
•
•
•

Using DHCP Option 43

You can use DHCP Option 43 to provide a list of controller IP addresses to the access points, enabling
the access point to find and join a controller. For additional information, refer to the
Option 43 for Lightweight Access Points" section on page
Cisco Aironet 1100 Series Access Point Hardware Installation Guide
6-2
The access points can only communicate with Cisco 2006 or 4400 series wireless LAN controllers.
Cisco 4100 series, Airespace 4012 series, and Airespace 4024 series wireless LAN
Note
controllers are not supported because they lack the memory required to support access points
running Cisco IOS software.
The access points do not support Wireless Domain Services (WDS) and cannot communicate with
WDS devices. However, the controller provides functionality equivalent to WDS when the access
point associates to it.
The access points support eight Basic Service Set Identifiers (BSSIDs) per radio and a total of eight
wireless LANs per access point. When the access point associates to a controller, only wireless
LANs with IDs 1 through 8 are pushed to the access point.
The access points do not support Layer 2 LWAPP. They must get an IP address and discover the
controller using DHCP, DNS, or IP subnet broadcast.
The access points do not have a console port.
You are unable to manually configure controller information on the 1100 series lightweight
Note
access point, because it does not have a console port.
Chapter 6 Troubleshooting Lightweight Access Points
"Configuring DHCP
F-1.
OL-4309-07