Priming Lightweight Access Points Prior to
Deployment
This section describes an optional procedure designed to prime or stage your lightweight access points
in a convenient location rather than after they are installed in possibly difficult to reach locations. This
process can be used when a DHCP server is not reachable by your deployed access point and it helps
limit potential installation problems to primarily Ethernet and power areas.
Figure E-1
Figure E-1
OL-4309-07
illustrates a typical priming configuration for your lightweight access points.
Typical Lightweight Access Point Priming Configuration
LWAPP
LWAPP
Cisco Aironet 1100 Series Access Point Hardware Installation Guide
A P P E N D I X
E
E-1