Table of Contents
Advertisement
Chapter 2
Installing the Access Point
Connecting the Ethernet and Power Cables
Powering Up the Access Point
When power is applied to the access point, it begins a routine power-up sequence that you can monitor
by observing the three LEDs on top of the access point. After you observe all three LEDs turning green
to indicate the starting of the Cisco IOS operating system, the Status LED blinks green signifying that
Cisco IOS is operational. Refer to the
"Checking the Autonomous Access Point LEDs" section on
page 5-2
or the
"Checking the Lightweight Access Point LEDs" section on page 6-3
for LED
descriptions.
Cisco Aironet 1100 Series Access Point Hardware Installation Guide
2-9
OL-4309-07
Hide quick links:
Advertisement
Table of Contents
