Controller Setup - Cisco 1230AG - Aironet - Wireless Access Point Configuration Manual

12.

Controller Setup

26
Reboot the Controller.
The initial setup of the controller is shown below.
The setup instructions outlined in this document are for the
configuration shown in the diagram only. Your configuration may
differ, and the appropriate adjustments must be made.
It is not necessary to configure each AP individually. The WLC is
capable of provisioning the APs.
1. From the main menu, click
2. Set the
Ethernet Multicast Mode
address that is currently not being used on your network for the
Multicast Group Address
3. Click the button.
Apply
4. Click
Save Configuration
VIEW Certified Configuration Guide
.
Controller
to and enter a multicast IP
Multicast
.
.
PN: 1725-36192-001_H