Reversing The Cable Management Arm (Optional); Initial Setup - Cisco Secure Network Server 3700 Series Hardware Installation Manual

Installing the Appliance
Step 4
Slide the CMA tab that is at the end of the width-adjustment slider onto the end of the stationary slide rail that is attached
to the rack post. Slide the tab over the end of the rail until it clicks and locks.
Step 5 Open the hinged flap at the top of each plastic cable guide and route your cables through the cable guides as desired.

Reversing the Cable Management Arm (Optional)

Step 1
Rotate the entire CMA assembly 180 degrees, left-to-right. The plastic cable guides must remain pointing upward.
Step 2 Flip the tabs at the ends of the CMA arms so that they point toward the rear of the appliance.
Step 3
Pivot the tab that is at the end of the width-adjustment slider. Depress and hold the metal button on the outside of the tab
and pivot the tab 180 degrees so that it points toward the rear of the appliance.
Figure 11: Reversing the CMA
1

Initial Setup

Note
CMA tab on end of width-adjustment
slider
This section describes how to connect to the system for initial setup.
Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide
Reversing the Cable Management Arm (Optional)
2 Metal button on outside of tab
23