Cisco 1230AG - Aironet - Wireless Access Point Configuration Manual page 34

34
Configuration for handsets running in 802.11a
mode
1. From the main menu, click
2. In the navigation pane, under
. All the APs that are connected should be listed, showing
802.11a /n
their
Operational Status
3. Select from the drop-down list for the access point you
Configure
wish to change.
Global settings for
were not tested. For
Assignment
settings please consult your facility's RF site survey — optimized for
wireless voice traffic — to determine correct power and channel
settings for each AP using non-overlapping channels.
4. Set to
Admin Status
5. Configure any other settings that might be relevant to your
deployment as needed.
6. Click the button to save all changes.
Apply
VIEW Certified Configuration Guide
.
Wireless
Access Points
as .
UP
RF Channel Assignment
Custom Tx Power
.
Enable
click then select
Radios,
and
Tx Power Level
and
RF Channel
PN: 1725-36192-001_H