Installing Software; Controller Setup - Cisco 1230AG - Aironet - Wireless Access Point Configuration Manual

Section 1: SVP

Installing Software

10. Add the
11. Allow a few minutes for the download to complete.
12. Reboot the Controller

Controller Setup

PN: 1725-36192-001_H
Cisco Wireless LAN Controllers with 1100, 1130, 1140, 1200, 1230, 1240, 1250 APs
1. Make sure that the correct version of software, listed in the Product
Summary, is installed on the controller. From the main menu, click
Monitor.
2. In the navigation pane, click
shows the current software version.
Version
3. Download the appropriate software for your model of controller from
the Cisco website
.
4. Set up a Trivial File Transfer Protocol (TFTP) server running on a PC
to download the file to the controller.
5. Connect to the controller via a Web browser.
6. From the main menu, click
7. In the navigation pane, click
8. For , select
File Type
9. For , type in the IP Address of the TFTP server.
TFTP Server
File Path
and not the system path where the TFTP server is located) and
of the firmware file to download.
Name
(Note the example simply uses the /designator for the root TFTP
directory.) Point the TFTP server to the code.
The initial setup of the controller is shown below.
. The heading labeled
Summary
.
Commands
Download File
.
Code
(this is the path in the TFTP server's root directory
Software
.
File
9