Advertisement
Quick Links
anovafurnishings.com
888.535.5005 tel
TOOLS NEEDED:
•
5/32" Allen wrench
•
1/4" Allen wrench
•
3/16" Wire pull rod
•
5/16" Open-end or
box-end wrench
BENCH COMPONENTS: Pattern may vary on the bench seat and backrest panels.
(1) Rear Backrest Panel
(1) Front Backrest Panel
ASSEMBLY HARDWARE: All hardware is stainless steel.
(16) 5/16"-18 x 1"
(6) 1/4"-20 x 5/8"
Allen Head Screws
Allen Head Screws
ASSEMBLY:
This is a two-person assembly.
1.
Inspect the shipping container contents for damage and to determine that all components and hardware are present.
2.
Lay all parts on a soft work surface or on the shipping packaging to prevent damage to the finish.
NOTE: Before assembling the nuts to the bolts, it is recommended that a light oil or petroleum jelly be applied to the screw threads.
Assembly Instructions
Tandem Contour Benches with Center Armrest
TAN3483P-6' - PERSPECTIVE
TAN3483MR-6' - MOUNTAIN RANGE
TAN3484P-8' - PERSPECTIVE
TAN3486P-12' - PERSPECTIVE
Tandem 6' Contour Bench
with Divided Seat
(1) Bench Seat
(6) 1/4" Flat
Washers
Tandem 8' Contour Bench
with Center Armrest
(1) Left End
Casting
Tandem 12' Contour Bench
with Center Armrest
(1) Right End
(1) Center Casting
Casting
1
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Anova PERSPECTIVE TAN3483P-6
Summary of Contents for Anova PERSPECTIVE TAN3483P-6
- Page 1 Assembly Instructions Tandem Contour Benches with Center Armrest TAN3483P-6' - PERSPECTIVE TAN3483MR-6' - MOUNTAIN RANGE TAN3484P-8' - PERSPECTIVE TAN3486P-12' - PERSPECTIVE anovafurnishings.com 888.535.5005 tel TOOLS NEEDED: • 5/32" Allen wrench • 1/4" Allen wrench • 3/16" Wire pull rod • 5/16"...
- Page 2 NOTE: The left end casting has two threaded holes about half way up the back leg and also has a channel in the bottom of the back leg for wires to run through. The right leg only has one threaded hole and does not have a channel.
- Page 3 Mount the other side of the front backrest panel to the center casting by inserting two 5/16"-18 x 1" Allen head screws. Mount the remaining front backrest panel in the same manner on the opposite side of the bench. Once both panels have been installed tighten the 5/16" screws with the 1/4" Allen wrench.
- Page 4 TAN3486P Tandem 12' Contour Bench w/Center Armrest, Perspective Tandem Assembly and Replacement Parts Rear Backrest Panel Front Backrest Panel Center Casting Bench Seat Right End Casting Left End Casting Note: Please contact Customer Care at 1-866-797-1761 when ordering replacement parts. 02/21/2018 Copyright 2018 ANOVA® Made in USA.
Need help?
Do you have a question about the PERSPECTIVE TAN3483P-6 and is the answer not in the manual?
Questions and answers