Extron electronics AMK 1 Installation Manual

AMK 1, AMK 2, and AMK 3 • Installation Guide
IMPORTANT NOTE:
Go to www.extron.com
Overview
ATTENTION:
• All structural steps and electrical installation must be performed by qualified personnel in accordance with local and
national building codes and electrical codes.
• Toute étape structurelle et installation électrique, doit être effectuée par un personnel qualifié, conformément aux codes
du bâtiment, aux codes incendie et sécurité, et aux codes électriques, locaux et nationaux.
These angle mount kits are used to mount touchpanels to walls or glass surfaces. The angle mount allows the touchpanel to be
mounted at a lower accessible height while still being viewable from higher or lower lines of sight.
• Use the AMK 1 to mount the TLS 525M and TLP Pro 525M.
NOTE:
The TLC Pro 526M is not compatible with the AMK1 due to the lack of clearance for the port expansion adapter.
•
Use the AMK 2 to mount the TLS 725M, TLP Pro 725M, and TLC Pro 726M.
• Use the AMK 3 to mount the TLS 1025M, TLP Pro 1025M, and TLC Pro 1026M.
This guide provides instructions for professional installers to mount and install these touchpanels using the appropriate AMK
mounting kit. The diagrams in this guide show the AMK 2 and TLP Pro 725M. Use the other kits to mount the corresponding
touchpanels in the same way.
The kits consist of:
•
(1) plastic enclosure (AMK 1, AMK 2, or AMK 3; see figure 1) with an
adhesive patch attached to the back. The enclosure ships with a metal plate
attached to the mounting posts (
• (1) cover overlay can be attached to the opposite face of the glass to
conceal the adhesive patch (see
• LED overlay (AMK 2 and AMK 3 only, see
• (4) M3 screws (6).
•
(1) 10 foot (3 meter) flat Ethernet cable with RJ-45 connectors.
You must also download the alignment template from www.extron.com. One
template is for the AMK 1. A second template is for both the AMK 2 and AMK 3.
Print it at 100% size. Do not scale.
Before Starting
To run cables to the back of the touchpanel, remove the cable access cover (see
figure 1, ) by releasing the catches (
E
There is a slot on either side of the cover (see figure 2,
accommodate the flat Ethernet cable. If you are using a larger cable, cut away
the plastic tabs ( ) from the sides of the cover using a sharp knife along the
H
groove in the plastic (see figure 1,
To replace the cover, slide the tabs (
enclosure and press the catches (
for the complete specifications.
).
A
figure 5
on page 3).
figure 6,
1
) and pulling the cover away.
D
G
).
F
) into the notches on the back of the
C
) back into place.
D
, on page 3).
) that can
A
B
C
D
E
Figure 1. AMK Enclosure (front view)
G
H
Figure 2. AMK Enclosure (side view)
F
1