Table of Contents
Advertisement
Using the DVC-000
Using the DVC-2000 in Broadband Mode
Status Message
Banner
Window
When powered on and after completing the Setup Wizard, the DVC-2000 is in PSTN
Mode. To enter Broadband Mode, press the Broadband button on the DVC-2000 and
the screen above will appear. The larger Main Window displays the self-view until a
call is connected and then displays the party you are calling. The smaller Self-View
Window then displays the self-view when a call is connected. To toggle the images that
are in the Main Window and Self-View Window press the Self/Remote button.
Status Icons
The Status Icons appear only briefly at startup. The DVC-2000 uses icons to indicate
the unit status. The icons appear on the upper right side of the Main Screen. If an
icon appears, it indicates an operation is not complete. The icon will disappear after
the operation has been completed. If the icon appears with a yellow "X" through it, this
means the operation was unsuccessful. If the Directory Service status icon is displayed
with an "X" through it, you can still make VideoPhone calls by entering the IP address
of the phone that you are calling (See Calling a VideoPhone or H.323 Device with
an IP Address on page 27). Below are the status icons:
Looking for i2eye updates
P
Obtaining the Public IP address (Router's Address)
D S
DVC-2000 is registering with the Directory Service
0
Layout of the i2eye Broadband Screen
Main
Win-
Area
Broadband.Mode
DVC-000 User's Manual
Status
Icons
Main
Settings
Buttons
Privacy
Status
Icons
Self-View
Window
D-Link Systems, Inc.
Advertisement
Table of Contents
