Figure 7.15 Nview Clone Mode Device Configuration - Nvidia P128 - Quadro FX2000 Dual Graphic Card 8x 128MB Model OEM User Manual

C h a p t e r 7
Follow these steps to enable Virtual Desktop:
From the nView Display Mode panel, right click monitor image 2 (secondary
1
display) to display the pop-up menu and select Change Resolution to
display the Device Configuration dialog box.
Note: If you do not see the Change Resolution option on the display 2 pop-up
Figure 7.15
Use the slider
2
equal to the Screen Resolution on the Windows Display Properties Settings
panel of your primary display.
Note: If you set the same Screen Resolution value for both primary and
Optional: If you want, you can select a refresh rate from the list box
3
Click Apply and OK. Notice that the resolution of your secondary display
4
changes and you can use your mouse to pan and scan the desktop on this
secondary display.
83
primary and/or secondary device by using the Device Configuration
dialog box shown below for the secondary display or the Windows
Settings tab of your primary display.
menu, adjust (increase) the resolution on the primary display until the
Change Resolution option becomes available from the display 2 pop-
up menu.
nView Clone Mode Device Configuration
(Figure 7.15) to set the Screen Resolution at a value that is not
secondary displays, you cannot pan/scan the desktop area on the
secondary display; both displays will remain static.
n V i e w D i s p l a y M o d e B a s i c s
N V I D I A C o r p o r a t i o n