Using Nview Multi-Display; Dualview Vs. Span/Clone; Nview Dualview Vs. Span And Clone Modes - Nvidia P128 - Quadro FX2000 Dual Graphic Card 8x 128MB Model OEM User Manual

C h a p t e r 5
This chapter contains the following major sections:
• "nView Dualview vs. Span and Clone Modes" on page 35
• "nView Dualview Mode" on page 38
• "nView Span and Clone Modes" on page 52
• "Enabling nView Modes: Windows NT 4.0" on page 62
• "Multi-Display Mode: Arranging Displays on the Windows Display
Properties Settings Panel" on page 62

nView Dualview vs. Span and Clone Modes

When using NVIDIA products that are multi-display capable, there are three
ways to run multi-display configurations under most operating system;
Dualview, Span, or Clone mode.
• nView Dualview and Span/Clone modes are mutually exclusive. This
means that you cannot access nView Span or Clone Mode if you have
Dualview mode enabled. Conversely, you cannot access Dualview mode if
you have nView Span or Clone Mode enabled.
Note: As explained in Chapter 1, the nView Display Mode option in the
35
U s i n g n V i e w M u l t i - D i s p l a y M o d e s : D u a l v i e w v s . S p a n / C l o n e
U V
SING N IEW
D
Media Center menu will always be visible when you are not in
Dualview mode (Figure
nView Display Mode option is replaced by the Device Selection option
(Figure 5.2).
M -D
ULTI ISPLAY
UALVIEW VS
5.1). When you are in Dualview mode, the
C
H A P T E R
M
ODES
. S /C
PAN LONE
N V I D I A C o r p o r a t i o n
: