Advertisement
Quick Links
ASSEMBLY INSTRUCTIONS FOR 10B5305 BOX GROUND ANCHORS
1. Unpack all parts and check for damage that may have occurred during shipping. If damage has occurred,
notify Kwik Goal immediately. Lay out all parts. Remove all cardboard and packaging immediately. Wet or
damp packaging may damage contents.
2. Read through entire instruction before beginning assembly and installation.
3. This anchor kit is intended for the 2B2001, 2B3306, 2B3406, 2B3706, 2B3804, 2B3805, 2B3806, 2B3906,
2B9004 and 2B9006 goals including goals with wheels and swivel wheel options. This kit may also be
compatible with other goals not listed.
NOTE: Components may be packaged in one or more additional boxes.
Parts
Anchor Box (4)
(Part# UZ1669)
Hardware
Note: Hardware may be packaged separately
in one or more boxes. Open all packages
before beginning assembly.
3/8" x 7/8" Hex Bolt
3/8" x 1" Hex Bolt
(Part# TZ290)
3/8" Flat Washer
(Part# TZ60)
3/8" Lock Washer
(Part# TZ65)
3/8" Square Nut
(Part# TZ247)
1/2" Flat Washer
(Part# TZ297)
Ground Anchor (4)
(Part# 10B103 Pack of 4)
(Part# TZ249)
140 Pacific Drive Quakertown, PA 18951
800-531-4252 Kwikgoal.com
w/ Snap Link & Anchor Plate
Assembly Tools
9/16", 3/4"
Wrench
(4)
(4)
(4)
(4)
(4)
(8)
©
2019 Kwik Goal Ltd.
Chain (4)
(Part# UZ846 )
9/16", 3/4" Socket
Socket Extension
1/2" x 1/2" Spacer (4)
(Part# TZ420)
Spacer Plate (4)
(Part# UZ1670)
Ratchet with
NZ453 Rev. 10/08/19
Advertisement
Related Manuals for KwikGoal 10B5305
Summary of Contents for KwikGoal 10B5305
- Page 1 ASSEMBLY INSTRUCTIONS FOR 10B5305 BOX GROUND ANCHORS 1. Unpack all parts and check for damage that may have occurred during shipping. If damage has occurred, notify Kwik Goal immediately. Lay out all parts. Remove all cardboard and packaging immediately. Wet or damp packaging may damage contents.
- Page 2 If this is not practical, store movable soccer goals in a place where children cannot have access to them. 10. Fully disassemble goals for seasonal storage. 140 Pacific Drive Quakertown, PA 18951 800-531-4252 Kwikgoal.com © 2019 Kwik Goal Ltd. NZ453 Rev. 10/08/19...
- Page 3 Ground Anchor 5. Layout and mark anchor locations. For 2B3306 and 2B3406 goals, refer to diagram below. For all other goals, locate anchors according to original goal instructions supplied with goal. Instructions are also available on kwikgoal.com. 312" 156" Ground Anchor locations 40"...
- Page 4 Prepare hole and add drain stone as shown. Note: areas subject to heavy frost may require depths as deep as 36”. Install anchor in each hole and fill hole with concrete. Allow concrete to cure. Do not allow concrete to block drain holes in sides of anchor box.
- Page 5 7. Install square nuts in bases of goal. Refer to original goal instruction for help with disassembly and reassembly of goal. Attach anchor plates to base of goal at same distance from goal face as anchors are from goal line as shown below.
- Page 6 8. Assemble goal to each of the four anchors with snap links as shown below. With goal leashed to all four anchors, test in accordance with step 9. 2B3306 & 2B3406 ONLY ***CAUTION*** This goal has been designed to be used for the game of soccer only. Goal posts must be anchored AT ALL TIMES and shall be secured against overturning.
- Page 7 4. If goal overturns during application of force or does not return to an upright position after removing force, an alternate anchoring system must be used Crossbar Go to kwikgoal.com for additional product information. ***CAUTION*** This goal has been designed to be used for the game of soccer only. Goal posts must be anchored AT ALL TIMES and shall be secured against overturning.
Need help?
Do you have a question about the 10B5305 and is the answer not in the manual?
Questions and answers