Delta Electronics AC Motor Drive VFD007S23A User Manual page 61

Chapter 5 Parameters|VFD-S Series
Pr.
Multi-Function Input Terminal 2 (M2)
4-05
Multi-Function Input Terminal 3 (M3)
4-06
Multi-Function Input Terminal 4 (M4)
4-07
4-08 Multi-Function Input Terminal 5(M5)
4-09 Line Start Lockout
4-10 Up/Down Mode
Accel/Decel Rate of Change of
4-11 UP/DOWN Operation with Constant
Speed
Group 5 Multi-Step Speed and PLC Parameters
Pr.
5-00 1st Step Speed Freq.
5-01 2nd Step Speed Freq.
5-6
Explanation
Explanation
Settings
d10: Jog Operation
d11: Accel/decel Inhibit
d12: First or Second
Acceleration/deceleration Time
Selection
d13: External base block (N.O.)
d14: External base block (N.C.)
d15: Up: Increment master
frequency
d16: Down: Decrement master
frequency
d17: Run PLC Program
d18: Pause PLC Program
d19: Counter Trigger Signal
d20: Counter Reset
d21: Select ACI / Deselect AVI
d22: PID Function Disabled
d23: JOG FWD
d24: JOG REV
d25: The source of master
frequency is AVI.
d26: The source of master
frequency is ACI.
d27: Press UP/DOWN key to switch
forward/reverse (N.O.) motion
d28: Press UP/DOWN key to switch
forward/reverse (N.C.) motion
d29: M0: 0: RUN 1: STOP, M1: no
function, Direction is controlled
by keypad
d0: Disable
d1: Enable
d0: Based on accel/decel time
d1: Up frequency according to
constant speed, down frequency
according to deceleration time
d2: Up frequency according to
acceleration time, down
frequenc according to constant
speed
d3: Constant speed
0~1000, unit: 5 Hz/sec
Settings
d0.0 to d400 Hz
d0.0 to d400 Hz
Revision August 2006, SE08, SW V2.61
Factory
NOTE
Setting
d6
d7
d8
d9
d0
d3
d1
Factory
NOTE
Setting
d0.0
d0.0