Delta Electronics AC Motor Drive VFD007S23A User Manual page 117

Chapter 5 Parameters|VFD-S Series
Group 9: Communication Parameters
9-00 Communication Address
Settings
If the AC drive is controlled by RS-485 serial communication, the communication address
must be set via this parameter.
9-01 Transmission Speed
Settings
Users can set parameters and control the operation of the AC drive via the RS-485 serial
interface of a personal computer. This parameter is used to set the transmission speed
between the computer and AC drive.
9-02 Transmission Fault Treatment
Settings
5-62
d1 to d254
RS485
Computer
d1
S1
d0 Baud rate 4800 bps (bits / second)
d1 Baud rate 9600 bps
d2 Baud rate 19200 bps
d3 Baud rate 38400 bps
d0 Warn and keep operating
d1 Warn and RAMP to stop
d2 Warn and COAST to stop
d3 No warning and keep operating
d3
d2
S1 S1
Revision August 2006, SE08, SW V2.61
Factory Setting: d1
Factory Setting: d1
Factory Setting: d0