Table of Contents
Advertisement
result to the blade, table insert or
turntable
if blade strike occurs
during the cutting operation.
1. To remove, loosen and remove the
six screws (1) on the table inserts
(2) with a Phillips screwdriver and
remove the insert.
2. To install, reposition the table
inserts, install the six screws and
tighten.
3. Check for blade clearance by
moving the slide carriage through
the full motion of the blade in the
table slot.
Fig. G
2
MOUNTING THE MITER SAW
(FIG. H, i)
®
®
handle. Carrying the tool by the
power cord could cause damage
to the insulation or the wire
connections resulting in electric
shock or fire.
To avoid injury from flying debris,
do not allow visitors
to stand
near the saw during any cutting
operation.
Support
the saw on a level work
surface.
Always
bolt or clamp the saw to
its support.
Mounting instructions
1. For stationary use, place the saw
in the desired location, directly on a
workbench where there is room for
handling and proper support of the
workpiece. The base of the saw has
four mounting holes. Bolt the base
of the miter saw (1) to the work
surface (5), using the fastening
method as shown in Fig H.
Fig. H
[,_
i
1. Miter saw base
WARNING
2. Hex head bolt
To avoid injury form unexpected
3. Rubber washer
saw movement:
4. Flat washer
o Disconnect
the power cord from
5. Workbench
the outlet, and lock the cutting
6. Flat washer
7. Lockwasher
head in the lower position using
8. Hex nut
the stop latch.
9. Jam nut
o Lock the slide carriage
in place
by tightening
the slide carriage
lock knob.
o To avoid back injury, lift the saw
by using the designated
carrying
handles located on the top of the
machine. When lifting,
bend at
2.
your knees, not from your back.
o Never carry the miter saw by
3
4
1
--r-
"
k I
NOTE: Mounting hardware is not
included with this tool. Bolts, nuts,
washers, & screws must be purchased
separately.
the power cord or by the switch
For portable use, place the
saw on a 3/4 in. thick piece of
plywood. Bolt the base of the
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
