Mounting The Miter Saw - Craftsman 137.375640 Operator's Manual

MOUNTING THE MITER SAW
(FIG. L, M)
Mounting instructions
1. For stationary use, place the saw
in the desired location, directly on a
workbench where there is room for
handling and proper support of the
workpiece. The base of the saw has
four mounting holes. Bolt the base of
the miter saw (1) to the work surface
(5), using the fastening method
shown in Fig. L.
Fig. L
1. Miter saw base 3 ---------I2_
2. Hex head bolt
3. Rubber washer 1
4. Flat washer
5. Workbench .__ ''
6. Flat washer 5 | ', ',
7. Lock washer
6/_-_:>
89
8. Hex nut 7
9. Jam nut
Fig. M
NOTE: Mounting hardware is not
included with this tool. Bolts, nuts,
washers, and screws must be
purchased separately.
2. For portable use, place the saw on
a 3/4 in. thick piece of plywood. Bolt
the base of the miter saw securely
to the plywood using the mounting
holes on the base. Use C-clamps
to clamp this mounting board to a
stable work surface at the worksite.
(Fig. M)