Craftsman 21194 - 7-1/4 in. Sliding Compound Miter Saw Operator's Manual page 17

i,A WARNING ]
To avoid injury, do not connect this
miter saw to the power source until
it is completely assembled and
adjusted, and you have read and
understood this Operator's Manual.
iNSTALLING THE MITER HANDLE
(FIG. A)
1. Thread the miter handle (1) into the
hole located at the front of the miter
table.
Fig. A
iNSTALLING THE DUST BAG (FIG. B)
1. Squeeze the metal collar wings of the
dust bag (1).
2. Place the dust bag neck opening
around the exhaust port (2), and
release the metal collar wings.
To empty the dust bag, squeeze the
metal collar and remove from exhaust
port. Open zipper on underside of bag
and empty into waste container.
NOTE: Check frequently and empty
bag before it gets full.
iNSTALLING THE SAFETY HOLD-
DOWN CLAMP (FIG. C)
1. Loosen the hex screw (3) using a
Phillips screwdriver from the rear
side of the saw base.
2. Place the hold-down clamp
assembly (1) in one of the mounting
holes (2).
3. Tighten the hex screw (3).
Fig. C
2C:: _Z_\::
J K \_
3 1
SAW BLADE WRENCH (FIG. D)
2 For convenient storage and prevention
of loss, there is a slot (1) in the right
side of the switch handle (2) for storing
the blade wrench (3) when not in use.
/, Fig.2 D_I
3
17