Table of Contents
Advertisement
Using the Web Configuration Page
Using the Voice Configuration Menu
Step 1
Step 2
Step 3
Step 4
Step 5
Using the Web Configuration Page
Caution
Cisco ATA 186 Installation and Configuration Guide
3-4
To manually configure the Cisco ATA 186 by using the interactive voice
response (IVR) system and telephone keypad, follow the steps in this section. For
a list of the available configuration options, see
Options."
Lift the handset and press the Function button located on top of the
Cisco ATA 186.
Enter the IVR menu number for the parameter that you want to configure or the
command that you want to execute; then, press the pound key (#). (See
Appendix A, "Voice Menu Options,"
Defaults,"
for lists of options and their corresponding menu numbers.)
Follow the applicable prompts.
When you have finished, make sure you press 3 to save your changes.
Hang up the telephone. The Cisco ATA 186 resets.he function button will
fast-blink when the reset is complete.
You can configure your Cisco ATA 186 by using the web configuration page.
Each configurable parameter is listed, and parameters are grouped and
color-coded according to their function.
Cisco recommends you do not perform the initial configuration over the
Internet; the configuration page is not secure. After you have configured the
parameters, password-protect the user interface to prevent it from being
accessed on the Internet. The parameter for password-protecting this page is
UIPasswd.
Follow these steps:
Chapter 3
Configuring the Cisco ATA 186
Appendix A, "Voice Menu
and
Appendix B, "Parameters and
OL-1267-01
Advertisement
Table of Contents
Troubleshooting
