Firmware Upgrade Parameters - Cisco ATA186-I1 Installation And Configuration Manual

Appendix B Parameters and Defaults

Firmware Upgrade Parameters

OL-1267-01
The upgradecode and upgradelang parameters are special parameters that provide
information on how to upgrade firmware code or language image.
The values are:
• upgrade_policy
hardware_version
•
• software_type
• software_version
tftp_ip_address
•
• tftp_port
image_id
•
firmware_image_file_name
•
All values must be present. Except for upgrade_policy field, Cisco supplies the
values to be used when a new upgrade image becomes available
The values are:
upgrade_policy—one of the following:
•
– default upgrade— software_type must be the same as the current
Cisco ATA 186. Internal software_type and software_version must be
greater than the current internal software_version for the upgrade to take
place.
– cross software type upgrade—the software_type can be different but
software_version must be greater than the current firmware internal
version.
force upgrade—the image_id is used to determine if the upgrade has been
–
performed (a different image ID from the Cisco ATA 186 internally
stored image ID means a forced upgrade is needed).
• hardware_version— 0x301. The hardware version must match exactly for
upgrade to take place.
tftp_ip_address, tftp_port—TFTP IP and port address where the firmware
•
can be found.
Cisco ATA 186 Installation and Configuration Guide
Firmware Upgrade Parameters
B-5