About The Software Upgrade Process - Cisco ATA186-I1 Installation And Configuration Manual

About the Software Upgrade Process

Note
About the Software Upgrade Process
Note
Cisco ATA 186 Installation and Configuration Guide
6-2
When upgrading from v1.34 to v2.0, the Cisco ATA 186 does not prompt the
user with the Upgrade Successful message when finished upgrading. Instead,
observe the function button LED. The LED will flash on and off during the
upgrade; then, change to a solid on state; then, turn off when the
Cisco ATA 186 has finished upgrading.
The following information is optional detailed information about the upgrade
process.
The available options when using the software upgrade are:
ata186us -h[host_ip] -p[port] -quiet image file
• -h[host_ip]—if the host has more than one IP address, use this option to set a
specific host IP address. The default is to use the first IP address obtained by
gethostbyname.
-p[port]—set the server port to specific port (default is 8000; use a different
•
port only if you are setting up an IP directed upgrade server other than the
default).
-quiet—set to quiet mode; that is, send all output to a log file named port.log.
•
This option is useful when the upgrade server is run as a daemon.
-any—allow upgrade even if the software version is older than or the same as
•
that of the client Cisco ATA 186.
-any2—allow upgrade regardless of software type and version.
•
• -d1,-d2,-d3—set level of detailed description for debugging.
Example:
ata186us -h123.456.789.100 -p5786 -quiet yj2e112.kup yj2e112.el
Chapter 6 Upgrading the Cisco ATA 186 Software
OL-1267-01