Call Command Behaviors - Cisco ATA186-I1 Installation And Configuration Manual

Appendix G Call Commands
Table G-3 Call Command Behaviors (continued)
Context
CONFIG: User configuring a supplementary
service
CALLING: Phone number is sent;
Cisco ATA 186 is waiting for response from the
far end
OL-1267-01
Commands
US
*69: Call Return #72v#: Forward unconditiona to
number specified in 'v'l; (PacBell use
72#)#73:Cancel any call forwarding; (PacBell use
73#)#74v#: Forward on busy to number specified in
'v'; (PacBell don't enable this service from the
phone)#75v#: Forward on no answer to number
specified in 'v'; (Pac Bell don't enable this service
from the phone)*67: CLIR in the next call (if global
profile is CLIP);*82: CLIP for the next call (if global
user profile is CLIR);*70: Disable call waiting in the
next call;*99: Enable Fax Mode in the next call;
(non-standard)
Sweden
*21*v#: Forward unconditionally to number
specified in 'v';*67*v#: Forward on busy to number
specified in 'v';*61*v#: Forward on no answer to
number specified in 'v';#21#: Cancel any call
forwarding;#67#: Cancel any call forwarding;#61#:
Cancel any call forwarding;#31#: CLIR in the next
call;*31#: CLIR in the next call; (Note: no CLIP,
maybe all calls by default is CLIP in Sweden?)*43#:
Enable call waiting in the next call (Sweden allows
globally disable call waiting?);#43#: Disable call
waiting in the next call;*69#: Call Return;
(non-standard)*99#: Enable Fax Mode in the next
call; (non-standard)All RegionsR or any
unrecognized sequence: Abort configuration, restart
dial-tone, and revert to PREDIAL;Any complete
configuration sequence: Carry out the configuration
command, restart dial-tone, and revert to PREDIAL
R: Cancel the outgoing call, restarts dial-tone, and
revert to PREDIAL
Cisco ATA 186 Installation and Configuration Guide
Syntax
G-9