Starting Or Joining A Meet-Me Conference Call - Cisco 7921G - Unified Wireless IP Phone VoIP Phone Manual

Tips
• Calls must be on the same line before you can add them to a conference. If calls are on different
lines, transfer them to a single line before using Confrn or Join.
• Depending on how your phone is configured, if you leave a conference after initiating it, the
conference might end. To avoid this, transfer the conference before hanging up.

Starting or Joining a Meet-Me Conference Call

Meet-Me conferencing allows you to start (initiate) or join a conference by dialing the conference
number.
If you want to...
Start a Meet-Me conference 1. Obtain a Meet-Me phone number from your system administrator.
Participate in a Meet-Me
conference
End a Meet-Me conference
Cisco Unified Wireless IP Phone 7921G for Cisco Unified CallManager 4.1, 4.2, 5.0 and Later
Then...
2. Distribute the number to participants.
3. When you are ready to start the meeting, choose Options >
MeetMe.
4. Dial the Meet-Me conference number.
5. Press the (green button).
Participants can now join the conference by dialing in.
Note Participants hear a busy tone if they call the conference before the
initiator has joined. In this case, participants must call back.
1. Dial the Meet-Me conference number (provided by the conference
initiator).
2. Press the (green button).
Note You will hear a busy tone if you call the conference before the
initiator has joined. In this case, try your call again.
All participants must hang up.
The conference does not automatically end when the conference
initiator disconnects.
Basic Call Handling
35