4 Installing an external DAT tape drive
In this chapter:
• "Connecting the power and USB
Please refer to
DAT tape drive.
Connecting the power and USB cables
NOTE:
The drive is not powered from the USB bus. It must be connected to the mains power supply.
An external HP StorageWorks DAT drive will operate using any voltage in the range 100–240 volts
(0.7 A, 50-60 Hz). No adjustment is needed.
A power cable is provided with your HP StorageWorks DAT tape drive. The USB 2.0 cable is already
fitted to the tape drive, you cannot remove it.
cables" on page 31
"Installing an internal DAT tape
drive" on page 23, if you are installing an internal
DAT USB Tape Drives
31