CODELOCKS EasyCode CL160 Change Instructions page 5

16/02/2022, 14:01 CL160 - Code Change Instructions
The spindle must project from the inside face of the door by at least 8mm (5⁄16") so as to
engage the handle. The spindle may have been cut too short during installation. Call the
helpline to obtain a longer spindle.
7. The inside lever handle does not return to the upright position after operating.
The lever return spring is broken.
Replacement spring required.
8. The latch does not engage and so the door remains unlocked after use.
The latch is not entering the strike.
Your door or frame may have warped since the lock was installed. Check that the latchbolt is
lined up with the strike aperture and adjust the position of the strike as necessary. Make sure
the deadlocking plunger cannot enter the strike aperture alongside the latchbolt when the
door is closed.
CC-CL160ML-v1:0218
© 2019 Codelocks Ltd. All rights reserved.
https:/ /desk.zoho.eu/portal/codelocks/en/kb/articles/cl160-code-change-instructions
5/5