CODELOCKS EasyCode CL160 Change Instructions page 3

16/02/2022, 14:01 CL160 - Code Change Instructions
6. Select and enter your new code rotating each digit clockwise using the code change tool
provided (FIG 5).
7. Press 'C' clear button followed by your new code. Rotate the lever fully (FIG 6) and the 'A'
button will revert to normal position.
Note: If 'A' button does not return refer to point 5 and check the position of the indictors. If
required reset all turning anti-clockwise as per FIG 3 and repeat steps.
8. If EasyCode Function is required, replace retaining screw behind 'A' button, to prevent on-
door code change. For QuickCode Function leave retaining screw out.
After Installation
A. Press 'A' button. If button will not depress, remove front plate from the door and follow
code change sequence from bullet points 1-7.
B. Press 'A' Button. If button will depress follow the code change sequence from bullet point 3
-6. Please ensure the door is held in the open position until code sequence has been verified.
Maintenance
No maintenance of the working parts is necessary. DO NOT OIL. To maintain the finish the
3/5