Table of Contents
Advertisement
Quick Links
Table of Contents
and Instructions
Items included in system
Float switches
³/��" weep holes
Lights and Alarms
Instruction Manual & Safety Warnings
2
2
3
3
3
4
5
5
5
Testing the System
5
5
6
6
Technical support
6
Warranty
6
Combination Primary and Backup Sump Pump System
7
7
7
8
8
9
10
10
10
10
11
11
11
11
11
12
Scan the QR code
13
for more information
about the PS-C33
14
Combination Sump
15, 16
Pump System
Model PS-C33
IMPORTANT: Even if you have the Pro Series™ C33
Combination Sump Pump System installed by someone
else, you must read and follow the safety information
contained in this manual. Failure to do so could result in
property damage, serious injury, or death.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Glentronics Pro PS-C33
Summary of Contents for Glentronics Pro PS-C33
-
Page 1: Table Of Contents
Instruction Manual & Safety Warnings Combination Primary and Backup Sump Pump System Model PS-C33 Table of Contents Important Safety Warnings Cleaning battery terminals and Instructions Not receiving AC power Electrical precautions Fuse alarm Battery precautions Backup pump activated Replacing the backup pump Introduction Replacing the primary pump Items included in system... -
Page 2: Important Safety Warnings
When service is required, electrical outlet before connecting or Warnings & Instructions have a licensed electrician replace it with a contact Glentronics' technical support disconnecting the battery cables. Never 3-prong receptacle according to local codes and at 800-991-0466. Return the product to SAVE THESE INSTRUCTIONS. -
Page 3: Introduction
Pro Series C33 • 1½" rigid PVC pipe to connect to the existing sump pump system. Glentronics can not (Model PJC, available from Glentronics, Inc.) system by purchasing a second battery... -
Page 4: Installing The Pipe And Pump
AND CONTROLLERS DO NOT FALL INTO THE Enhanced Float Controller Consider a Pro Series Battery Backup Sump Pump System Glentronics, Inc. 800.991.0466 www.stopflooding.com Adjust pump timer from 5-45 seconds using a flat head screw driver. Seconds SUMP PIT. 12 Amps... -
Page 5: Battery Instructions
Enhanced Float Controller only run the pump for a short time and will Consider a Pro Series Battery Backup Glentronics, Inc. 800.991.0466 www.stop ooding.com Sump Pump System the controller into a properly grounded Adjust pump timer from 5-45 seconds using a at head screw driver. -
Page 6: Controllers
If the battery is good, contact be silenced, but the light will stay on. To after the lower float drops. The blue controller Glentronics’ service department for silence the alarm for 24 hours, hold down for the primary pump powers this process. -
Page 7: Cleaning Battery Terminals
2. If the pump wires are intact, the pump may using a surge protector.) If the fuse blows be clogged. (a) Disconnect both control units again, call Glentronics technical support at from the wall outlet, and disconnect the battery 800-991-0466. -
Page 8: Backup Pump Activated
Then call Glentronics technical 3. Remove the cover of the battery box and support for instructions at 800-991-0466. • Check the main pump for failure. It may not fan the area around the top of the battery You may need to replace the pump. -
Page 9: Replacing The Primary Pump
REPLACING THE PRIMARY PUMP pump will separate from the pump when the screws are removed. SAVE THESE Before you begin this SCREWS or replace them with #10-24 x process, you will need 1½" stainless-steel screws. a new AC pump, new 8. -
Page 10: Battery Power Level
If the security system requires a closing commonly available, or you may order this of a contact to activate the alarm, secure part (#1141007) from Glentronics. the other wire in the terminal hole labeled 10. Remove the screws from the strainer on N.O. -
Page 11: Connect Module
However, DO NOT hold the float up for an You can receive technical support, parts, or extended time without water in the sump pit. service information by calling Glentronics, Inc., at 800-991-0466 or by visiting the Pro While the pumps are active, water will come Series website at www.stopflooding.com. -
Page 12: Replacement Parts Diagram & List
Replacement Parts List TOP VIEW PS-C33 Description Part Controller for backup pump PHCC-2400-CONT Enhanced dual float switch with controller for AC pump DFC1.5 ¹/� HP AC sump pump S3033-NS PHCC-2400 backup pump 1011013 Battery box 1113003 PVC wye pipe and 45° elbow 1120017 Sump foot 1143000... -
Page 13: Troubleshooting Guide
Defective pump ......problem continues, contact Glentronics customer service at 800-991-0466. Page 13... -
Page 14: Limited Warranty
GLENTRONICS, INC., this warranty shall no longer be valid. Prior to defective operation, the unit must not have been previously altered, repaired or serviced by anyone other than GLENTRONICS, INC., or its agent; the serial number on the unit must not have been altered or removed; the unit must not have been subject to accident, misuse, abuse or operated contrary to the instructions contained in the accompanying manual. -
Page 15: Other Products
Additional Products to Help Protect Your Basement Maintenance Free Battery Clenit Pump and Pro Series CONNECT Sewage Pump Pit Cleaner WiFi2 Module B12-100 E7055 PS-WIFI2 FEATURES AND BENEFITS: ƒ Sends emails, texts or in-app notifications Compatible with: and status alerts to your phone, tablet or computer ƒ... - Page 16 FEATURES AND BENEFITS: ƒ For use with 360˚ Sensor (PS-WS360) and EXT-PWA20 Water Sensor (PS-WS) ƒ 20' cord ƒ Rubber gasket and sleeve for waterproofing the connection between the extension and sensor © 2023, Glentronics, Inc. 1806191 09/23 Page 16...
Need help?
Do you have a question about the Pro PS-C33 and is the answer not in the manual?
Questions and answers