Seneca KEY-C Series User Manual page 31

10. RESETTING THE DEVICE TO ITS FACTORY CONFIGURATION
The factory configuration resets all parameters to default.
To reset the device to the factory configuration it is necessary to follow the procedure below:
Z-KEY-C / Z-KEY-2ETH-C:
1) Remove power from the device
2) Turn dip switches 1 and 2 to ON
3) Power up the device and wait at least 10 seconds
4) Remove power from the device
5) Turn dip switches 1 and 2 to OFF
6) At the next restart the device will have loaded the factory configuration
R-KEY-LT-C:
1) Remove power from the device
2) Set dip switches 1 and 2 of SW2 to ON
3) Power up the device and wait at least 10 seconds
4) Remove power from the device
5) Turn 2 SW2 dip switches to OFF.
6) At the next restart the device will have loaded the factory configuration
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION MAY
BE REPRODUCED WITHOUT PRIOR PERMISSION.
User Manual
www.seneca.it
MODBUS TO CLOUD
"KEY-C" GATEWAYS
MI00725-1-EN
Page 31