Seneca KEY-C Series User Manual page 21

Set the waiting time for a response from the Modbus slave serial device, after this time without any response
there will be a TIMEOUT.
PORT#n DELAY BETWEEN POLLS [ms]
Set the pause between two successive serial Modbus master requests.
PORT#n WRITING RETRIES (Only for Gateway Tags Modbus mode)
Set the number of attempts to write to the TAG(s) before setting the FAIL status.
PORT#n MAX READ NUM (Only for Gateway Tags Modbus mode)
Set the maximum number of registers that can be read with the multiple reading functions (the gateway will
optimize readings with this maximum number of registers). It must be adjusted according to the maximum
number of registers that can be read at the same time by the slave device.
PORT#1 MAX WRITE NUM (Only for Gateway Tags Modbus mode)
Set the maximum number of registers that can be written with the multiple writing functions (the gateway will
optimize writings with this maximum number of registers).
WEB SERVER PORT
Set the TCP-IP port for the Webserver.
WEB SERVER AUTHENTICATION USERNAME
Set the username for accessing the Webserver (if the user name and password are left blank, no authentication
is required to access the Webserver)
WEB SERVER AUTHENTICATION PASSWORD
Set the password for accessing the Webserver (if the username and password are left blank, no authentication
is required to access the Webserver)
CHANGE THE DEFAULT USERNAME AND PASSWORD IN THE WEBSERVER TO RESTRICT ACCESS.
IF THE TWO PARAMETER TEXT BOXES ARE LEFT EMPTY, THE AUTHENTICATION FOR ACCESS IS
WEBSERVER HTTPS
It forces the webserver to use the https secure protocol instead of http one
ETHERNET IP CHANGE FROM DISCOVERY
Set whether a user is authorized to change the IP configuration from the "Seneca Discovery Device" software.
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION MAY
BE REPRODUCED WITHOUT PRIOR PERMISSION.
User Manual
ATTENTION!
ATTENTION!
REMOVED.
www.seneca.it
MODBUS TO CLOUD
"KEY-C" GATEWAYS
MI00725-1-EN
Page 21