Seneca KEY-C Series User Manual page 23

WATCHDOG TIMEOUT [hours]
Sets the time in hours after which the gateway will reboot (only if the WATCHDOG ENABLE parameter is
enabled).
SYNC CLOCK WITH INTERNET TIME
Allows you to enable date/time updating via connection to NTP servers
AT EACH SWITCHING OFF THE DEVICE MUST BE ABLE TO RETRIEVE THE DATE/TIME FROM AN NTP
NTP SERVER 1 ADDRESS
This is the IP address of the first NTP server (for example 193.204.114.232 for INRIM's NTP)
NTP SERVER 2 ADDRESS
This is the IP address of the second NTP server (in case the first one does not respond)
PLEASE REMEMBER THAT NTP SERVERS USE THE UDP 123 PORT (WHICH MUST THEREFORE
ALWAYS BE OPEN IN THE CONFIGURATION OF THE NETWORK USED)
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION MAY
BE REPRODUCED WITHOUT PRIOR PERMISSION.
User Manual
SERVER OTHERWISE THIS WILL BE SET TO 1/1/1970 0:00
ATTENTION!
ATTENTION!
www.seneca.it
MODBUS TO CLOUD
"KEY-C" GATEWAYS
(RFC 5905).
MI00725-1-EN
Page 23