Page 1
USER MANUAL English Español Model: ITV205 Email service@rainpointus.com WhatsApp +1 626-780-5952 Free Hotline US: 1-833-381-5659 (EN) EU: +44 800-808-5337 (EN DE) Save the user manual for future reference If you have any questions, please contact us to get support...
Page 3
WARM TIPS PLEASE READ BEFORE USING Don’t use the water timer when the temperature is below 37°F(3°C), and please store the timer indoors to avoid potential freezing damage. The filter traps dirt particles, preventing them from entering the timer and causing clogging. Please clean the filter regularly and replace it if worn.
PRODUCT OVERVIEW AT A GLANCE FILTER HOSE TAP CONNECTION OK/MANUAL BUTTON DIAL BIG LCD DELAY/+ SCREEN BUTTON - BUTTON ZONE 1 ZONE 2 ZONE SWITCH BUTTON DIAL : Rotate the dial to customize your watering schedule; Save the changes (settings). Switch between ZONE 1 and ZONE 2.
DIAL POSITION FUNCTION Timer waters according to your customized schedule for both zones Turn off all watering SPECIFICATION Working Water Pressure 0.5bar-8bar (7 psi-116 psi) Max Flow Rate 10 Gal/Min (35L/Min) Waterproof Level IP54 Working Temperature 37.4℉-122℉ (3℃-50℃) Working Voltage DC 2.3V~DC 3.3V Watering Frequency Every 1-12 hours or Every 1-7 days...
PRODUCT INSTALLATION INSTALLING THE BATTERIES 1) Remove the battery compartment cover on the back of the timer. 2) Insert 2 new AAA (1.5V) alkaline batteries (not included). 3) Put the battery compartment cover back on the timer and press firmly to make sure it is completely sealed.
INSTALLING THE TIMER 1) Turn off the garden faucet. 2) Wrap Teflon Tape around the faucet threads. 3) Screw the timer to the garden faucet and make the display is as vertical as possible to the ground to prevent rainwater from accumulating and leaking into the interior.
Page 8
If yes, the timer valves are normal, please use it with confidence! If not, please repeat the step 2-5 several times or contact RAINPOINT support team immediately. Note: When testing, please keep away from the water timer outlet to avoid being splashed and wet.
PROGRAMMING THE TIMER STEP 0: UNDERSTANDING ZONES This is a two-zone timer allowing you to water two different areas from the same faucet. Each zone can be programmed with independent start time, how long, and how often. Note: Dual zones operating simultaneously have lower water pressure than single zone because the water pressure is divided between the two zones.
STEP 2: START TIME 1) Turn dial to"START TIME". 2) Use"+"and"-"buttons to set your start time. 3) Use"OK"button to switch time( Hours or Minutes). 4) Turn the dial clockwise to save the changes in this STEP and go to the next STEP. TIPS: When the setup of this STEP is finished, please turn the dial to save the changes instead of press the "OK"...
Page 11
STEP 4: HOW OFTEN 1) Turn dial to"HOW OFTEN". 2) Use"+"and"-"buttons, to set your watering frequency.You can choose to water every 1 to 12 hours,or every 1 to 7 days. (NOTE:1 is every day, 2 is every other day,etc.) 3) Turn the dial clockwise to save the changes in this STEP and go to the next STEP.
STEP 5: AUTOMATIC WATERING Next 1)Turn dial to "ON". 2)The LCD screen will display the current time and the next watering start time in Zone 1, and then display the current time and the next watering start time in Zone 2. Next Current time Next watering...
ADDITIONAL FUNCTIONS RAIN DELAY MODE Turn the dial to "ON", Press the "+" or "-" Press the "OK" button press and hold the button to adjust the to start rain delay "DELAY" button delay watering time Rain delay allows you to postpone watering on both zones for a set period of time without interrupting your set watering schedule.
Page 14
MANUAL/HAND WATERING Turn the dial to Press the "ZONE" Press the "+" or Press the "OK" "ON", press and button to select "-" button to button to start hold the "MANUAL" the zone to be adjust the manual manual watering button watered watering time This function allows you to manually water without interrupting your set...
USE ONLY ONE OF THE ZONES If you want to use only ZONE 1 and close ZONE 2, please set it up as follows. 1) Turn the dial to "START TIME" and press "ZONE" to select ZONE 2. 2) Press the "+" or "-" button to adjust the Hour until the screen displays OFF.
TROUBLESHOOTING Issue Possible Cause Advice The water inlet 1. No filter or not be 1. Add filter and make sure leakage placed horizontally it' s placed horizontally in 2. The faucet is not the the inlet. Right standard 3/4" 2. Make sure the faucet is a 3/4"...
Page 17
Low water 1. Filter blockage 1. Check if the filter is pressure 2. Inlet pressure not clogged, if so, clean or sufficient to support replace the filter. watering 2. Make sure the timer is installed properly and not cross-threaded. 3. Installation of a booster pump or other auxiliary equipment of increasing pressure.
Page 18
CLEANING YOUR TIMER After a period of use, impurities or dirt in the water may accumulate in the timer. Therefore, the timer should be cleaned regularly to ensure its proper operation. Please follow these steps to clean the timer. 1. Turn off the garden faucet and remove the timer. Check whether the filter at the timer water inlet has accumulated impurities.
Page 19
WARNINGS 1) For outdoor use only. Placing the timer in the sheltered outdoors will prolong its lifetime. 2) To avoid damage, please tighten it without using tools. 3) The filter should be placed horizontally in the water inlet to prevent leakage.
To place a warranty request, please email us with your order ID at service@rainpointus.com and we'll respond within 24 hours. CUSTOMER SERVICE Still have trouble with setup, please search for "RainPoint" on YouTube for installation videos! If the user manual doesn't have what you're looking for or you need other help, please contact us before returning the product to the store and let us know the LOT NO.
Page 21
CONSEJOS DE SEGURIDAD POR FAVOR LEA ANTES DE UTILIZAR No utilice el temporizador de agua cuando la temperatura está por debajo de 37°F(3°C), y por por favor almacene en el interior para evitar daños potenciales por congelamiento. El filtro atrapa las partículas de suciedad, evitando que entre al temporizador y se produzcan atascos.
VISTA DEL PRODUCTO EN UNA MIRADA FILTRO GRIFO DE BOTÓN OK/ MANGUERA MANUAL DIAL PANTALLA DELAY/+ - BOTÓN ZONA 1 ZONA 2 BOTÓN DE CAMBIO DE ZONA DIAL : Gire el dial para personalizar su programa de riego; Guarde los cambios (configuración).
Page 23
FUNCIÓN POSICIÓN DEL DIAL HOW OFTEN Elija con qué frecuencia regará cada zona El temporizador riega de acuerdo a su horario personalizado para cada Zona Apaga todo el riego ESPECIFICACIÓNES Presión de Agua de Trabajo 0.5bar-8bar (7 psi-116 psi) Caudal Máximo 10 Gal/Min (35L/Min) Nivel de Impermabilidad IP54...
INSTALACIÓN DEL PRODUCTO INSTALANDO LAS BATERÍAS 1) Retire la tapa del compartimiento de las baterías en la parte posterior del temporizador 2) IInserte 2 baterías alcalinas AAA (1.5V) nuevas (no incluidas) 3) Coloque nuevamente la tapa del compartimiento de las baterías en el temporizador y presione firmemente para asegurarse de que está...
Page 25
INSTALANDO EL TEMPORIZADOR 1) Cierre el grifo del jardín. 2) Envuelva la cinta de Teflón alrededor de la rosca del grifo. 3) Enrosque el temporizador en el grifo del jardín y haga que la pantalla quede lo más vertical posible respecto al suelo para evitar que el agua de lluvia se acumule y se filtre hacia el interior 4) Envuelva la Cinta de Teflón alrededor de...
Page 26
Si no, por favor repita los pasos 2-5 varias veces o contacte al equipo de soporte de RAINPOINT inmediatamente. Nota: Cuando realice la prueba, por favor mantenga alejado de la salida de agua del temporizador para evitar que se salpique y se moje.
PROGRAMANDO EL TEMPORIZADOR PASO 0: COMPRENDIENDO LAS ZONAS Este es un temporizador de dos zonas que le permite regar dos áreas diferentes a partir del mismo grifo. Cada zona se puede programar con un tiempo de inicio, duración y frecuencia diferente. Nota: El funcionamiento simultáneo de ambas zonas produce una presión de agua más baja que cuando opera en una sola zona debido a que la presión de agua se divide para las dos zonas.
PASO 2: HORA DE INICIO 1) Gire el dial a "START TIME". 2) Utilice los botones "+"y "-"para configurar la hora de inicio. 3) Utilice el botón "OK"para cambiar la hora ( Horas o Minutos). 4) Gire el dial en el sentido de las agujas del reloj para guardar los cambios en este PASO y continuar al siguiente PASO.
Page 29
PASO 4: FRECUENCIA 1) Gire el dial a "HOW OFTEN". 2) Utilice los botones "+"y "-"para configurar la frencuencia de riego. Puede elegir cada 1 a 12 horas, o cada 1 a 7 días. (NOTA:1 es todos los días, 2 es cada dos días,etc.) 3) En este PASO, gire el dial en el sentido de las agujas del reloj para continuar al siguiente PASO.
Page 30
PASO 5: RIEGO AUTOMÁTICO Next 1) Gire el dial a "ON". 2) La pantalla LCD mostrará la hora actual y la siguiente hora de inicio del riego en la Zona 1, y luego mostrará la hora actual y la próxima hora de inicio del riego en la Zona 2.
FUNCIONES ADICIONALES MODO RETRASO POR LLUVIA Gire el dial a "ON", Presione el botón "+" o Pulse el botón "OK" para pulse prolongadamente "-" para ajustar el tiempo iniciar el retraso por lluvia el botón "DELAY" de retraso del riego El retraso por lluvias le permite posponer el riego en ambas zonas por un periodo de tiempo establecido sin interrumpir el programa de riego configurado.
Page 32
RIEGO MANUAL/A MANO Gire el dial a Pulse el botón Presione el botón Pulse el botón "OK" "ON", presione y "ZONE" para "+" o "-" para para iniciar el riego Mantenga presionado Seleccionar la ajustar e tiempo de manual El botón "MANUAL" zona a regar riego manual Esta función le permite regar el agua manualmente sin interrumpir el...
USO DE UNA SOLA ZONA Si desea utilizar solo la ZONA 1 y cerrar la ZONA 2, por favor configúrela de la siguiente manera. 1) Gire el dial a "START TIME" y presione "ZONE" para seleccionar la ZONA 2. 2) Pulse el botón "+" o " " para ajustar la Hora hasta que la pantalla muestre OFF.
RESOLUCIÓN DE PROBLEMAS Problema Posible Causa Consejo Fuga en la 1. No tiene el filtro o no 1. Agregue el filtro y entrada está colocado asegúrese de que está horizontalmente de agua ubicado horizontalmente 2. El grifo no es el en la entrada.
Page 35
Baja presión 1. Bloqueo del filtro 1. Compruebe si el filtro está bloqueado, si es así, de agua 2. La presión de la limpie o reemplace el entrada no es suficiente filtro. para soportar el riego 2. Asegúrese de que el temporizador esté...
Page 36
LIMPIANDO SU TEMPORIZADOR Después de un tiempo de uso, las impurezas y suciedad en el agua se pueden acumular en el temporizador. Por lo tanto, el temporizador se debe limpiar regularmente para asegurar el correcto funcionamiento. Por favor siga estos pasos para limpiar el temporizador. 1.
Page 37
ADVERTENCIAS 1) Solo para uso en exteriores. Colocar el temporizador en el exterior protegido prolongará su vida útil. 2) Para evitar daños, por favor apriete sin utilizar herramientas. 3) El filtro se debe colocar horizontalmente en la entrada de agua para prevenir fugas.
GARANTÍA Rainpoint ofrece 1 año de garantía contra defectos de fabricación en los materiales y la mano de obra a partir de la fecha de compra. Durante el periodo de garatía, reemplazaremos sin costo el producto que se encuentre defectuoso, bajo un uso y servicio razonable según lo determinado únicamente porRainPoint.
Page 40
Scan the QR code to get fast support Need Help? Please contact us US Free Hotline: +1 833-381-5659 (MON-FRI: 09:30 AM-5:30 PM PST) UK Free Hotline: +44 800-808-5337 (MON-FRI: 09:00 AM-5:00 PM CET) Email: service@rainpointus.com WhatsApp: +1 626-780-5952...
Need help?
Do you have a question about the ITV205 and is the answer not in the manual?
Questions and answers