Programming From Other Remote Controls - Yamaha RX-A2000 Owner's Manual

SOURCE RECEIVER
iENTER
7 Press
"OK" appears in the display window if setting was
AV
d
1 2 3 4 successful.
5 6 7 V-AUX
"NG" appears in the display window if the setting was
AUDIO
1 2 3 4
unsuccessful. In this case, start over from step 3.
PHONO MULTI USB NET
DOCK TUNER SIRIUS [ A ]
SCENE
e
1 2 3 4
If you continuously want to set up another code for
another control area, repeat steps 4 to 7.
BSETUP
8 Press
i
ENTER
menu.
If operation is not possible and the manufacturer of
your component has more than one code, try each of
them until you find the correct one.
CATEGORY
TUN./CH
NOTES
• "ERROR" appears in the display window on the
remote control if you press a button not indicated in
B
the respective step, or when you press more than one
SETUP
button simultaneously.
• The supplied remote control does not contain all
possible codes for commercially available audio and
video components (including Yamaha components). If
operation is not possible with any of the remote
control codes, program the new remote control
function using the learning feature
the remote control supplied with the component.
• Functions programmed using the learning mode take
priority over remote control code functions.
■
Switching between BD player
to set the number.
linked to scene selections
Press
dAV2
"OK" appears in the display window if setting was
successful.
OK
Then you can operate the external components by switching
the input source to AV2, or selecting AV2 in the registered
scene.
Same steps for operating other external components, press
again to exit from the setup
e
SCENE
selected in step 3 and hold it for approximately 3 seconds.
(☞p. 132 ) or use
Controlling the remote control to operate various functions
eSCENE and at the same time press
and hold it for approximately 3 seconds.
OK
and at the same time press the input source key
SETUP
Programming from other remote
controls
The remote control of this unit can receive remote
control signals from other remote controls and learn the
remote control operation. If a key on the remote control
does not work after being assigned with an external
component's function or if the remote control code for
that function is not provided, use this learning feature to
make the function operable with the remote control.
• Perform each of the following steps within 30 seconds.
Settings will be automatically stopped if more than 30
seconds passes since the last operation. To reset, repeat
from step 1.
• If the remote control of the external component uses
infrared rays, this remote control can learn most of its
functions. The remote control may not recognize
special or consecutive signals.
• The keys may not operate the assigned functions
depending on operating conditions of this unit.
Press BSETUP.
1
"SETUP" appears in the display window.
iCursor B / C
2 Press repeatedly to select
"LEARN" and press iENTER.
Continues to the
En
next page
132