Yamaha RX-A2000 Owner's Manual page 46

SOURCE RECEIVER
■
When an error message is
displayed during measurement
See "Error messages"
AV
1 2 3 4
resolving the problem and measure acoustics again.
5 6 7 V-AUX
AUDIO
1 2 3 4
PHONO MULTI USB NET
DOCK TUNER SIRIUS
[ A ]
Check the error code displayed and use YPAO to
measure acoustics again as described below.
i
When "E-1," "E-2," "E-3," "E-4" or "E-6" is
ENTER
displayed:
Press iENTER.
1
iCursor E
2 Press
iENTER
3 Press
switch the unit to standby mode.
Check that the speakers are properly
4
connected.
5 Turn on the unit and use YPAO again.
When "E-7" or "E-8" is displayed:
Press iENTER.
1
Check that the environment is suitable for
2
accurate measurement.
3
(☞p. 47) for instructions on
4
When "E-5" or "E-9" is displayed:
1
2
3
to select "EXIT."
4
to terminate YPAO, and
When "E-10" is displayed:
1
2
3
4
iCursor E
Press to select "RETRY."
Press iENTER to use YPAO again.
Press iENTER.
Check that the environment is suitable for
accurate measurement.
iCursor D / E
Press to select a option.
PROCEED:
When "E-5" is displayed, measurement can proceed.
However, the measurement in noisy environment may
reduce the accuracy.
When "E-9" is displayed, resume the aborted step.
RETRY:
Restart measurement from the beginning.
iENTER
Press to execute the selected
option.
Press iENTER.
iCursor E
Press to select "EXIT."
iENTER
Press to terminate YPAO, and
switch the unit to standby mode.
Turn on the unit and use YPAO again.
CONNECTIONS
Setting up the speaker parameters automatically (YPAO)
■
When a warning message is
displayed after measurement
See "Warning messages" (☞p. 47) for instructions on
resolving the problem. The speaker causing the problem
can be confirmed from the TV screen display.
NOTE
Although the results of acoustics measurement can be
applied when a warning message is displayed, optimal
sound will not be achieved. Resolving the problem
and using YPAO to measure acoustics again is
recommended.
To exit YPAO with some options
iCursor B / C
Use to select "Save/Exit"
1
and press iENTER.
iCursor D / E
2 Use to select one of the
following options and press iENTER.
SAVE:
Exits YPAO applying the results of measurement.
CANCEL:
Returns to the previous screen (warning message
screen).
EXIT:
Exits YPAO without saving the results.
46
En