Covers And Panels; Top Front Cover; Bottom Front Cover; Control Panel - Vulcan-Hart SG4C Service Manual

COVERS AND PANELS

electrical power to the machine and
follow lockout / tagout procedures.

Top Front Cover

1. The top front cover is secured with four
screws, two on each side of cover. Remove
these screws, then remove the cover from
the oven.
REMOVE SCREWS
TOP FRONT COVER
2. Reverse the procedure to install.

Bottom Front Cover

1. The bottom front cover is secured with six
screws, two on each side of cover and two on
the top. Remove these screws then remove
the cover from the oven.
REMOVE SCREWS REMOVE SCREWS
BOTTOM FRONT COVER BOTTOM FRONT COVER
2. Reverse the procedure to install.
Disconnect the
ON
HEAT
IGNITION
PL-56040
PL-56041
– 7 –

Control Panel

1. Remove three screws on the right side which
secure the control panel. Pull the panel away
from the oven.
SG4D SHOWN
2. Disconnect the temperature probe leads from
the solid state temperature controller.
3. Unplug the wire harness connector to the
control panel components.
4. Reverse the procedure to install.

Right Side Panel

1. Remove the screws that secure the right side
of the control panel.
2. Remove the remaining screws securing the
right side panel.
3. Pull the right-side panel out at the bottom
then down to remove.
RIGHT SIDE RIGHT SIDE
4. Reverse the procedure to install.
CONTROL
PANEL
REMOVE
SCREWS
FAN SPEED LIGHTS
HI ON
LOW OFF
PL-56042-1
REMOVE REMOVE
SCREWS SCREWS
PL-56043