Removal And Replacement Of Parts; Covers And Panels; Top Front Cover; Bottom Front Cover - Vulcan-Hart VC4G Service Manual

VC4G & VC6G SERIES FULL SIZE CONVECTION OVENS - REMOVAL AND REPLACEMENT OF PARTS

REMOVAL AND REPLACEMENT OF PARTS

COVERS AND PANELS

electrical power to the machine and
follow lockout / tagout procedures.
SHUT OFF THE GAS BEFORE
SERVICING THE UNIT.

Top Front Cover

1. The top front cover is secured with four (4)
screws, two on each side of cover. Remove these
screws then remove the cover from the oven.
Fig. 1
2. Reverse the procedure to install.

Bottom Front Cover

1. The bottom front cover is secured with four (4)
screws, two on each side of cover. Remove these
screws then remove the cover from the oven.
Fig. 2
2. Reverse the procedure to install.

Control Panel

1. Remove three (3) screws on the right side which
secure the control panel then pull the panel away
from the oven.
Disconnect the
Page 7 of 75
Fig. 3
NOTE: If the oven has a mechanical (KX type)
thermostat, it must be removed from the control panel
first, before removing the control panel.
2. Disconnect the temperature probe leads from the
solid state temperature control.
3. Unplug the wire harness connector to the control
panel components.
4. Reverse the procedure to install.

Right Side Panel

1. Remove the screws which secure the right side
of the top front cover, bottom front cover and
control panel.
2. Remove the remaining six screws securing the
right side panel.
Fig. 4
3. Pull the right side panel out at the bottom then
down to remove.
4. Reverse the procedure to install.
F24682 Rev. D (1016)