Covers And Panels; Top Front Cover; Bottom Front Cover; Control Panel - Vulcan-Hart SG4D ML-114875 Service Manual

COVERS AND PANELS

WARNING: DISCONNECT (UNPLUG) ELECTRICAL
POWER SUPPLY AND PLACE A TAG AT THE
DISCONNECT SWITCH INDICATING YOU ARE
WORKING ON THE CIRCUIT.

Top Front Cover

1. The top front cover is secured with four
screws, two on each side of cover. Remove
these screws, then remove the cover from
the oven.
REMOVE SCREWS
TOP FRONT COVER
2. Reverse the procedure to install.

Bottom Front Cover

1. The bottom front cover is secured with six
screws, two on each side of cover and two on
the top. Remove these screws then remove
the cover from the oven.
REMOVE SCREWS REMOVE SCREWS
BOTTOM FRONT COVER BOTTOM FRONT COVER
2. Reverse the procedure to install.

Control Panel

ON
HEAT
IGNITION
PL-56040

Right Side Panel

PL-56041
– 7 –
1. Remove three screws on the right side which
secure the control panel. Pull the panel away
from the oven.
SG4D SHOWN
2. Disconnect the temperature probe leads from
the solid state temperature controller.
3. Unplug the wire harness connector to the
control panel components.
4. Reverse the procedure to install.
1. Remove the screws that secure the right side
of the control panel.
2. Remove the remaining screws securing the
right side panel.
3. Pull the right-side panel out at the bottom
then down to remove.
RIGHT SIDE RIGHT SIDE
4. Reverse the procedure to install.
CONTROL
PANEL
REMOVE
SCREWS
LIGHTS
FAN SPEED
HI ON
LOW OFF
PL-56042
REMOVE REMOVE
SCREWS SCREWS
PL-56043