Install Ferrite Core - Vivotek IP8132 User Manual

VIVOTEK
General I/O Terminal Block
This Network Camera provides a general I/O terminal block which is used to connect external
input / output devices. The pin definitions are described below.
Pin
4 Power
3 Digital Output +
2 Digital Input -
1 Ground
Hardware Reset
The reset button is used to reset the system or restore the factory default settings� Sometimes
resetting the system can return the camera to normal operation� If the system problems remain
after reset, restore the factory settings and install again�
Reset: Press and release the recessed reset button with a paper clip or thin object. Wait for the
Network Camera to reboot�
Restore: Press and hold the recessed reset button until the status LED rapidly blinks orange.
Note that all settings will be restored to factory default� Upon successful restore, the status LED
will blink green once per second during normal operation�

Install Ferrite Core

1� Unsnap the two halves of the ferrite core�
2� Attach the ferrite core to the power cord as close to the DC connector as possible� Fold the
ferrite core over the power cord, wrap the power cord once, and snap the small latches
together�
Ferrite Core
6 - User's Manual
Name