Route Guidance; Retrieve Position Information; Trip Meter - Nokia 002J3X4 User Manual

The coordinates in the GPS are expressed in degrees
and decimal degrees format using the international
WGS-84 coordinate system.
To use GPS data, the GPS receiver of your device must
initially receive position information from at least four
satellites to calculate the coordinates of your location.
When the initial calculation has been made, it may be
possible to continue calculating the coordinates of
your location with three satellites. However, the
accuracy is generally better when more satellites are
found.

Route guidance

Select Menu Applications
>
Navigation.
Start the route guidance outdoors. If started indoors,
the GPS receiver may not receive the necessary
information from the satellites.
Route guidance uses a rotating compass on the device
display. A red ball shows the direction to the
destination, and the approximate distance to it is
shown inside the compass ring.
Route guidance is designed to show the straightest
route and the shortest distance to the destination,
measured in a straight line. Any obstacles on the route,
such as buildings and natural obstacles, are ignored.
Differences in altitude are not taken into account when
calculating the distance. Route guidance is active only
when you move.
86
GPS GPS data and
> >
To set your trip destination, select
destination and a landmark as the destination, or
enter the latitude and longitude coordinates.
To clear the destination set for your trip, select
navigation.

Retrieve position information

Select Menu Applications
>
Position.
In the position view, you can view the position
information of your current location. An estimate of the
accuracy of the location is displayed.
To save your current location as a landmark, select
Options Save position. Landmarks are saved
>
locations with more information, and they can be used
in other compatible applications and transferred
between compatible devices.

Trip meter

Select Menu Applications
>
Trip distance.
The trip meter has limited accuracy, and rounding
errors may occur. Accuracy can also be affected by
availability and quality of GPS signals.
To turn trip distance calculation on or off, select
Options Start orStop. The calculated values remain
>
on the display. Use this feature outdoors to receive a
better GPS signal.
To set the trip distance and time and average and
maximum speeds to zero, and to start a new
Options Set
>
Stop
GPS GPS data and
> >
GPS GPS data and
> >
© 200 9 Nokia. All rights reserved.