Wlan Internet Access Points - Nokia 002J3X4 User Manual

User name — The user name may be needed to
•
make a data connection, and is usually provided by
your service provider.
Prompt password
•
to ask for a password every time you log in to a
server, or if you do not want to save your password
in the device, select Yes.
Password — A password may be needed to make
•
a data connection and is usually provided by your
service provider.
Authentication
•
your password encrypted or
password encrypted when possible.
Homepage — Depending on the access point type
•
you are setting up, enter the web address or the
address of the multimedia message centre.
Use access point
•
set the device to ask for confirmation before the
connection using this access point is created, or
Automatically
destination using this access point automatically.
Select Options
>
following:
Network type
•
to transfer data to and from your device. The other
settings depend on the selected network type.
Phone IP address
•
address of your device.
DNS addresses
•
primary and secondary DNS servers, if required by
your service provider. To obtain these addresses,
contact your internet service provider.
156
— If you want to set the device
— Select Secure to always send
Normal to send your
— Select After confirmation
to set the device to connect to the
Advanced settings and from the
— Select the internet protocol type
(for IPv4 only) — Enter the IP
— Enter the IP addresses of the
Proxy server address
•
proxy server.
Proxy port number
•
the proxy server.

WLAN internet access points

Select Menu Control panel
>
Connection Destinations
>
follow the instructions on the display. Or, open one of
the access point groups, select an access point marked
with , and select Edit.
Use the instructions provided by your service provider
to edit the following:
WLAN network name
•
Search for networks. If you select an existing
to
network, WLAN network mode
security mode are determined by the settings of its
access point device.
Network status
•
name is displayed.
WLAN network mode
•
an ad hoc network, and to allow devices to send and
receive data directly; a WLAN access point device is
not needed. In an ad hoc network, all devices must
use the same WLAN network name.
WLAN security mode
•
used: WEP, 802.1x
WPA/WPA2. If you select
encryption is used. The WEP, 802.1x, and WPA
functions can be used only if the network supports
them.
— Enter the address of the
— Enter the port number of
Settings and
>
Access point, and
>
— Select Enter manually
and WLAN
— Define whether the network
— Select Ad-hoc to create
— Select the encryption
(not for ad hoc networks), or
Open network, no
© 200 9 Nokia. All rights reserved.
or