Table of Contents
Advertisement
Use access point
•
set the device to ask for confirmation before the
connection using this access point is created or
Automatically
destination using this access point automatically.
To enter the settings for the selected security mode,
select
WLAN security
Advanced WLAN settings
Select
Options
>
following:
IPv4 settings
— Enter the IP address of your device,
•
the subnet IP address, the default gateway, and the
IP addresses of the primary and secondary DNS
servers. Contact your internet service provider for
these addresses.
IPv6 settings
•
Ad-hoc channel
•
enter a channel number (1-11) manually, select
defined.
Proxy server address
•
proxy server.
Proxy port number
•
number.
Packet data (GPRS) settings
Select
Menu
Control panel
>
Connection
Packet
>
Your device supports packet data connections, such as
GPRS in the GSM network. When you are using your
© 200 9 Nokia. All rights reserved.
— Select
After confirmation
to set the device to connect to the
settings.
Advanced settings
and from the
— Define the type of DNS address.
(only for ad hoc networks) — To
— Enter the address for the
— Enter the proxy port
Settings
>
data.
to
device in GSM and UMTS networks, it is possible to have
multiple data connections active at the same time;
access points can share a data connection, and data
connections remain active, for example, during voice
calls.
To define the packet data settings, select
connection
device to the packet data network when you switch the
device on in a supported network, or
register the device to a packet data network only when
an application or action attempts to establish a packet
data connection. This setting affects all access points
for packet data connections. To use the device as a
packet data modem for your computer, select
point, and enter the access point name provided by
your service provider. To use a high-speed data
connection, select
Enabled.
User
WLAN settings
SelectMenu
Connection
To have an indicator displayed when there is a wireless
LAN (WLAN) available in your current location, select
Show WLAN availability
To select the interval for your device to scan for
and
available WLANs, and to update the indicator, select
Scan for
networks. This setting is not available unless
you select
and
When available
to register the
High speed packet access
Control panel
Settings
>
>
Wireless
LAN.
>
> Yes.
Show WLAN availability
Packet data
When needed
to
Access
>
and
> Yes.
157
Advertisement
Table of Contents
