Route Guidance; Retrieve Position Information; Trip Meter - Nokia N76-1 Positioning

The coordinates in the GPS are expressed in degrees and
decimal degrees format using the international WGS-84
coordinate system.
To use GPS data, your device must be connected to a
compatible GPS receiver. The GPS receiver must receive
position information from at least three satellites to
calculate the coordinates of your location.

Route guidance

To use route guidance, select Navigation. Start the route
guidance outdoors. If started indoors, your compatible GPS
receiver may not receive the necessary information from
the satellites.
Route guidance uses a rotating compass on the device
display. A red ball shows the direction to the destination,
and the approximate distance to it is shown inside the
compass ring.
Route guidance is designed to show the straightest route
and the shortest distance to the destination, measured in
a straight line. Any obstacles on the route, such as
buildings and natural obstacles, are ignored. Differences in
altitude are not taken into account when calculating the
distance. Route guidance is active only when you move.
To set your trip destination, select
destination and a landmark as the destination, or enter
Options > Set
the latitude and longitude coordinates. Select
navigation to clear the destination set for your trip.

Retrieve position information

To view the position information of your current location,
connect your device to a compatible GPS receiver and
select Position. An estimate of the accuracy of the
location is shown on the display.
To save your current location as a landmark, select
Options > Save position. Landmarks are saved locations
with more information, and they can be used in other
compatible applications and transferred between
compatible devices.

Trip meter

Select Trip distance > Options
distance calculation and Stop
calculated values remain on the display. Use this feature
outdoors to receive a better GPS signal.
Select Reset to set the trip distance and time and average
and maximum speeds to zero and to start a new
calculation. Select Restart
total time to zero.
Copyright © 2007 Nokia. All rights reserved.
Stop
> Start to activate trip
to deactivate it. The
to also set the odometer and
5