Call waiting
— Set the device to notify you of
•
incoming calls while you are in a call (network
service).
Internet call waiting
•
you of a new incoming internet call while you are in
a call.
Internet call alert
•
to alert for incoming internet calls. If you select
Off, you receive only a notification if you missed a
call.
Reject call with message
•
a text message to the caller.
Message text
•
that is sent when you reject a call.
Own video in recvd. call
•
sending during a video call from your device.
Image in video call
•
is not sent during a video call.
Automatic redial
•
maximum of 10 attempts to connect the call after
an unsuccessful call attempt. To stop automatic
redialling, press the end key.
Show call duration
•
during the call.
Summary after call
•
after the call.
Speed dialling
•
Anykey answer
•
Line in use
— This setting (network service) is
•
shown only if the SIM card supports two subscriber
numbers, that is, two phone lines. Select which
phone line you want to use for making calls and
sending text messages. Calls on both lines can be
© 200 9 Nokia. All rights reserved.
— Set the device to notify
— Select
On
to set your device
— Reject a call, and send
— Write the standard text message
— Allow or deny video
— Display a still image if video
— Set your device to make a
— Display the length of a call
— Display the length of a call
— Activate speed dialling.
— Activate anykey answer.
answered irrespective of the selected line. If you
select
Line 2
and have not subscribed to this
network service, you are not able to make calls.
When line 2 is selected,
screen.
Line change
— Prevent line selection (network
•
service), if supported by your SIM card. To change
this setting, you need the PIN2 code.
Network settings
Select
Menu
Control panel
>
Phone
> Network.
To select the network mode, select
and
Dual
mode, UMTS, or GSM. In dual mode, the
device switches automatically between networks.
Tip: Selecting
UMTS
but may increase the demand on battery power
and reduce the battery life. In regions close to
both GSM and UMTS networks, selecting
mode
may cause constant jumping between the
two networks, which also increases the demand
on battery power.
To select the operator, select
Manual
to select from available networks, or
Automatic
to set the device to select the network
automatically.
To set the device to indicate when it is used in a
microcellular network (MCN), select
display
> On.
is displayed in the home
Settings
and
>
Network mode
enables faster data transfer,
Dual
Operator selection
and
Cell info
153