Sherman digitec SYNERGIC DIGIMIG 202 M-POWER User Manual page 3

Machine Translated by Google
• Use protective curtains made of non-flammable materials and choose the right wall colors
absorbing harmful radiation.
Prevention of poisoning by vapors and gases emitted during welding from electrode coating and metal
evaporation:
• Use ventilation devices and exhaust systems installed in places with limited air exchange.
air,
• Blow with fresh air when working in a confined space (tanks),
• Use masks and respirators.
Burn prevention:
• Wear appropriate protective clothing and footwear to protect against radiation burns.
arc and splinters,
• Avoid contaminating clothing with grease and oils that may cause ignition.
Explosion and fire prevention:
• It is prohibited to operate the device and weld in rooms with a risk of explosion or
fire,
• The welding station should be equipped with fire extinguishing equipment,
• The welding station should be located at a safe distance from flammable materials.
Preventing the negative impact of noise:
• Use earplugs or other noise protection measures,
• Warn people nearby about dangers.
WARNING!
Do not use an electrical source to thaw frozen pipes.
Before starting the device, you must:
• Check the condition of electrical and mechanical connections. It is forbidden to use handles and power cables
with damaged insulation. Improper insulation of handles and power cables may cause electric shock,
• Ensure proper working conditions, i.e. ensure proper temperature, humidity and ventilation in the workplace.
work. Outside closed rooms, protect against atmospheric precipitation,
• Place the charger in a place where it can be easily operated.
People operating a welding machine should:
• have the qualifications for electric welding using the MIG/MAG method,
• know and comply with the occupational health and safety regulations applicable to welding work,
• use appropriate, specialist protective equipment: gloves, apron, rubber boots, shield
or a welding helmet with a properly selected filter,
• be familiar with the contents of this instruction manual and use the welding machine in accordance with its intended purpose.
Any repairs to the device may only be performed after disconnecting the plug from the power socket.
When the device is connected to the mains, it is not permitted to touch any elements forming the welding current
circuit with bare hands or through wet clothing.
It is prohibited to remove external covers when the device is connected to the mains.
Any modifications to the rectifier on your own are prohibited and may constitute a deterioration of safety conditions.
All maintenance and repair work may only be carried out by authorised persons in compliance with the work safety
conditions applicable to electrical devices.
It is prohibited to operate the welding machine in rooms at risk of explosion or fire!
The welding station should be equipped with fire extinguishing equipment.
After finishing work, the device's power cord must be disconnected from the mains.
The above-mentioned hazards and general health and safety rules do not exhaust the issue of welder's work safety,
because they do not take into account the specifics of the workplace. An important supplement to them are workplace
health and safety instructions and training and instruction provided by supervisory employees.