Circontrol eVolve Series Installation Manual page 8

2
Before the installation
A)
Important safety instructions
Read carefully all the instructions before starting in order
to ensure properly installation of the Charge Point.
The Charge Point is designed for installation at indoor and outdoor
areas. For each of the different conditions of installation, the unit must be
installed safely and ensure adequate protection.
• Charge Point must not be installed
in areas where there is potential
risk of explosion or any salinity
level.
• Charge Point must not be installed
in industrial areas with high level of
humidity or pollutants.
• Do not install the Charge Point
where falling objects may
damage the equipment.
• The surface where the Charge
Point is placed must withstand the
mechanical forces.
• Do not use this unit for anything
other than electric vehicle
charging modes are expected in
IEC 61851-1.
• Do not modify this unit. If
modified, CIRCONTROL will
reject all responsibility and
the warranty will be void.
08
• Comply strictly with electrical
safety regulations according to
your country.
• Do not make repairs or
manipulations with the unit
energised.
• Only trained and qualified
personnel should have access
to the electrical parts inside the
Charge Point.
• Check the installation annually by
qualified technician.
• Remove from service any item
that has a fault that could be
dangerous for users (broken plugs,
caps that don't close...).
• Use only Circontrol supplied spare
parts.
• Do not use this unit if the enclosure
or the EV connector is broken,
cracked, open, or shows any
other indication of damage.
CIRCONTROL — eVolve Series — Installation Manual