ekwb EK-Quantum Vector3 FE RTX 5090 User Manual page 7

Gpu water block

Hide thumbs Also See for EK-Quantum Vector3 FE RTX 5090:

PREPARING THE GRAPHIC CARD

IO BRACKET

STEP 1

LED PCB

STEP 2

REMOVING THE STOCK COOLER

NVIDIA FE GEFORCE RTX 5090

Important! Before starting, make sure to have a clean,

flat surface to work on. It is recommended to put foam

or soft material to lay the graphics card on.

STEP 1

First, remove two (2) screws from the back of the stock cooler (with

a Torx head screwdriver).

Unscrew four (4) screws to remove the I/O bracket, then unscrew

nine (9) I/O ports screws.

STEP 2

Gently lift the frame by prying it with a thin plastic tool starting from

the left. The frame is attached magnetically along the card.

Unscrew two (2) Phillips head screws from the frame and remove

the LED PCB. You will need it in a later step.

- 7 -

Need help?

Do you have a question about the EK-Quantum Vector3 FE RTX 5090 and is the answer not in the manual?