Stage 1 Preparing To Install The Prince In The Car; Harness Adjustment - Britax PRINCE Manual

Prince_Page_3.pdf
Stage 1 - Preparing to install the PRINCE in the car
You must adjust the height of the shoulder straps
in a car.

Harness adjustment

Too high
The shoulder straps
shoulders. If in any doubt always use the slot above the shoulder rather than below it. However, once you
reach the top slots your child may continue to use the seat until their eye line is above the top of the seat
shell or their weight exceeds 18kg.
C
1
M
Y
CM
MY
CY
Loosen the harness by pushing
the adjuster button in as you
pull the shoulder straps
forward as much as possible.
3
Now take the chest pad tab
and twist it so that a thin edge
will go through the slot first.
Push the tab through to the
front of the PRINCE.
12/09/2008 15:24:30
Too low
MUST be threaded through the slots in the cover and shell nearest the top of your child's
2a
Lift the connection piece out
from behind the seat-belt
guard and unhook one
shoulder strap.
Your connection piece design will be one of the above. Depending
on the design, the shoulder straps will attach to the connection
piece as shown in figure 2a or 2b.
4
Re-thread the chest pad re-
taining tab back through your
chosen shoulder slot in the
cover and seat. Make sure it is
not twisted.
BEFORE you install your child seat
Correct
2b
Pull the strap through to the
front of the PRINCE and out of
the chest pad.
5
Chest
Pad Tab
Now re-thread the shoulder
strap through the chest pad
and then through your chosen
slot. Make sure the shoulder
strap lies on top of the chest
pad tab and is not twisted.
page 3
Shoulder
Strap