Removing And Cleaning The Harness Buckle - Britax PRINCE Manual

Prince_Page_11.pdf

Removing and cleaning the harness buckle

Food and drink may find their way inside the buckle of the PRINCE harness. This can stop it from working
properly. Follow the instructions below if you
1
With one hand pulling on the buckle and the other
hand under the seat, twist the end bracket, found
underneath the seat, sideways and then push it up
through the slot.
C
M 3
Y
CM
MY
CY
Then latch and unlatch the tongues into the buckle
several times until a strong audible click is heard. If you
still cannot hear a strong audible click after latching the
buckle several times run the buckle under warm water
again.
When the buckle does fasten with an audible click
leave it to dry.
IMPORTANT - NEVER
of the harness buckle.
12/09/2008 15:16:01
DO NOT
lubricate or oil any part
hear a click when fastening the buckle.
2
Clean buckle with mild hand soap and water. Rinse
thoroughly with warm water.
4
To re-fit the buckle to your car seat hold the end
bracket sideways and insert it into the seat slot. Make
sure the red buckle button faces away from your child
seat.
lf the buckle still does not return to its original working
order, contact the Britax Customer Services Helpline
on (01264) 386034.
page 11