Icom IC-475H Instruction Manual page 11

80 VFO EQUALIZING SWITCH [A-B]
(p. 33) ,
ага
ЕЕВС
©
= (= DOOOOOODN jos
87) NOTCH FILTER SWITCH [NOTCH] (p. 30)
(91351513
С опсооооос-
60 МОТСН FILTER CONTROL [NOTCH]
(p. 30)
3 HE
© јест
© CETT]
(АЙ DO00000DN
С.
89 РА5Б5ВАМО TUNING [PBT] (р. 30)
е
е
О ===
@ RIT SWITCH [RIT] (р. 31)
oe
© momo
О те
eee)
[X саооооос-
Жавар
L
@RIT CLEAR SWITCH [RIT-CL] (p.31)
Жавар
X
@ INCREMENTAL TUNING CONTROL
[- RIT +] (p.31)
ФЕ = (9)
00000000 =
0) МЕМОВҮ READ SWITCH [MEMO]
(p. 33)
Е
E
о КЕТТЕ
Юза [осоро obs
59 ODOOOOODN
ш
4) МЕМОВҮ WRITE SWITCH [MW] (р. 34)
AAG р
This switch instantly matches the frequency and mode of operation
of the two VFOs.
e The display does not change when the [A-B] SWITCH is pushed.
However, confirmation of the equalizing process is possible by
pushing the [VFO] SWITCH which checks the frequency and
mode of the opposite VFO.
This switch turns the NOTCH FILTER circuit ON and OFF.
This control shifts the NOTCH FILTER frequency.
control to reduce or eliminate interfering signals.
Adjust the
This control allows continuous tuning of passband selectivity by
moving the filter center frequency to either side of the receive fre-
quency in the SSB or CW mode.
This switch turns the RIT circuit ON and OFF. The "RIT" IN-
DICATOR appears on the FREQUENCY DISPLAY when the RIT
function is activated.
This switch clears the memory which contains the frequency shift
information and resets the small incremental tuning display to 70.0".
This switch selects the MEMORY CHANNEL mode. The "MEMO"
INDICATOR appears on the FREQUENCY DISPLAY, and the
"VFO A" or "VFO B" INDICATORS disappear.
Push this switch to store displayed information in a memory
channel.