Setup Mode - TallyGenicom LA800+ User Manual

User guide

Setup mode

Adjust Paprpath
Menu Char
1 2 3 4
In this mode, the following settings are available:
Setup key: Sets the printer to setup mode, in which the following
settings can be selected:
Online
Menu key (1): Other menu settings. Acces may be disabled by
the manufacturer (see note below).
Setup
Adjust key (2): Sets the Tear position, first printing line and print
head gap.
Paprpath key (3): Sets the Paper path.
Char key (4): Sets the font and number of characters per inch.
Access to the other menu settings (Menu) may be – depending
on the model – disabled by the manufacturer.
Proceed as follows to release this lock temporarily.
1 Switch off the printer for approx. 5 seconds.
2 Switch the printer on again keeping the Setup key pressed until
Selftest disappears on the display.
For information on how to enable access permanently and
about the available settings, refer to the section
(MenLock) (page 66)
The settings for Font and CPI are lost when the printer is
switched off. The section
explains how to set fonts permanently.
and Menu parameters
Selecting font (Font)
The control panel
Menu lock
(page 51).
(page 53)
29