Midea MRF29D9BST User Manual page 20

3. Dispensing ice cubes
Touch the
•
Manual ice dispensing: Hold the cup close to the dispenser spout to avoid ice spills. Press the
•
cup against the dispenser paddle to dispense ice cubes. Release the paddle to stop dispensing.
Automatic ice dispensing: Place the cup in the center of the drip tray, press the
•
once, the dispenser chute will automatically descend to the rim of the cup (if the cup is short,
the chute will descend to the lowest level) and start dispensing ice cubes. Upon completion, the
chute will ascend back to its initial position.
4. Dispensing ice & water
EN
Touch the
•
The Ice & Water function is only available in automatic mode.
•
Place the cup in the center of the drip tray, press the
•
will automatically descend to the rim of the cup (if the cup is short, the chute will descend to
the lowest level) and start dispensing ice cubes. When the set amount of ice cubes is dispensed
(default is half the cup height, adjustable via the APP), cold water begins to flow. Upon
completion, the chute will ascend back to its initial position.
Function switching
In automatic water dispensing mode, if you switch to CRUSHED, CUBED, or ICE & WATER
function during water dispensing, the dispenser chute will first return to the top position and
then descend to perform the appropriate function.
Cautions
The amount of water displayed when dispensing water is an approximation and is not used as
•
measurement data.
When using the CRUSHED, CUBED, or ICE & WATER function, cups less than 160mm in height
•
may cause the AutoFill function to not work. This is because ice cubes may fall out of a lower
cup during AutoFill, creating a safety hazard if someone steps on them and slips.
When using AutoFill, be careful not to put your hands or other objects between the cup and
•
water spout to avoid interfering with detection and causing a malfunction. If the "Check Cup"
prompt appears when attempting to use AutoFill, simply remove the cup from the dispenser
and replace it after a few seconds. The AutoFill function will then return to normal use.
button until the indicator icon
button until the indicator icon
lights up.
lights up.
button once, the dispenser chute
20
button